Jump to content

Recommended Posts

Hey Everyone!

So the issue is... I am using Voronoi to fracture an object. The inside and outside faces are in two groups named 'inside' and 'outside'.

I'm using the 'assemble' node to pack the primitives however, doing this, it looses the 'inside' and 'outside' groups which I need to use later on. 

 

Is there a way to use the assemble node and keep the groups?

Any advice is massively appreciated!

Thanks All!

Edited by MilesS1

Share this post


Link to post
Share on other sites

Turn on "Transfer Groups" in the assemble SOP. Check if there are any attribs you want to transfer if so tick that on too

Share this post


Link to post
Share on other sites
6 minutes ago, lugnut said:

Turn on "Transfer Groups" in the assemble SOP. Check if there are any attribs you want to transfer if so tick that on too

Hey John, 

Thanks of replying. I am placing the 'inside' & 'outside' groups in the 'Transfer Groups' field in the assemble sop. It transfers the 'inside' and 'outside' groups but testing with the delete node, the groups transfer over but the geometry within each group changes?

Basically the geometry in the 'inside' group is different once it has been through the assemble node. (Same applies for the 'outside' group)

Is it something I'm doing wrong in the assemble node?

Thanks again for replying!

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×