Jump to content

Leaderboard


Popular Content

Showing most liked content on 03/06/2021 in all areas

  1. 1 point
    ok i fixed it, the problem was the axis alignment option. it should be set to None not Island symmetry
  2. 1 point
    Here is one way sample_test.hipnc
  3. 1 point
    Here is the i@stopped attribute included inside the if statement. I dropped the viscosity threshold, quite a bit, so the fluid would come to a stop quicker. if (@viscosity>3600){ @viscosity = 3600; @v = set(0,0,0); i@stopped = 1; } ap_SimCon1.hiplc
×