Jump to content
Sign in to follow this  
Fiszka

SOP Solver - Overwriting Parameters

Recommended Posts

Hey. I have a problem with overwriting values from wire object in SOP Solver. If klinear parameter (Linear Spring Constant) is set to 300 in wire object and then I'm writing inside sopsolver in point wrangle @klinear = 300; just for test, then my simulation looks different, less stabile (?). Why is that happening? This is the same value so it should be the same sim. I was trying to put sopsolver before and after the wire solver and there was the same situation.

Share this post


Link to post
Share on other sites

It's a multplier isnt it, so you effectively got 300*300=90000 ?

  • Like 1

Share this post


Link to post
Share on other sites

Hmm. Actually it's not a multiplier. If there's value 300 in wire object and @klinear = 1; in sopsolver then the value is much closer to 1 then 300.

Share this post


Link to post
Share on other sites

Ok. Sorry, it's my bad. It looks like it's multiplier :) Thanks a lot, it's working :)

But why it's doing multiplication? How does it work?

Edited by Fiszka

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×