PortalPyro98 0 Posted August 6, 2019 Hi, I'm currently working through Steven Knippings Applied Houdini Rigids 3 series and just got a bit stuck at the section where he converts hard constraints into glue constraints using a Prim wrangle inside a SOP solver. I've looked into the geo spreadsheet and it seems to do the conversion but the problem is when this happens the strength should be set to -1 and never break apart but instead all the pieces break apart and go flying. Tried messing around with different strength values and methods but can't seem to figure it out. Any help would be appreciated. I've included the project folder with some flipbooks and screenshots of what I'm talking about. Thanks Heli.zip HardConstraintTest(ODForce).avi Share this post Link to post Share on other sites
Atom 1,194 Posted August 6, 2019 You do have a misspelling of the attribute, @strength. 1 Share this post Link to post Share on other sites
PortalPyro98 0 Posted August 7, 2019 13 hours ago, Atom said: You do have a misspelling of the attribute, @strength. Haha... That's it, god I feel stupid now. Thanks a lot for pointing it out though. Share this post Link to post Share on other sites