Jump to content
Sign in to follow this  
eunchae

About vellum's weld constaint

Recommended Posts

Hello, everyone.

I am working on a saliva.

I want to work with vellum ...

The split does not break even when using weld.

Look at my hip file and let me know what's wrong.

Thank you.

saliva_test.hipnc

Share this post


Link to post
Share on other sites
4 hours ago, eunchae said:

The split does not break even when using weld.

what are you welding? there is no split in your curves

I added some splits, also you had some additional Stitch constraints being created in the dops so I disabled those otherwise they'd stitch those breaks back again

saliva_test_fix.hipnc

Share this post


Link to post
Share on other sites
Posted (edited)
7 hours ago, anim said:

what are you welding? there is no split in your curves

I added some splits, also you had some additional Stitch constraints being created in the dops so I disabled those otherwise they'd stitch those breaks back again

saliva_test_fix.hipnc

Thanks for the reply.

But I don't understand.

I want to break the line.( By making some conditions ...)

Grouped points to be cut and used a weld constraint, but this has no effect.

I am not sure how to use it.

Thank you. ( I am using Houdini version 17.5.)

Edited by eunchae

Share this post


Link to post
Share on other sites

here is file that will work in 17.5, and maybe even simpler technique, but essentially the same, the point is that you have to have the pieces separate to begin with and then Weld will just temporarily weld them until the threshold is reached

saliva_test_fix_17.5.hipnc

  • Thanks 1

Share this post


Link to post
Share on other sites
21 minutes ago, anim said:

here is file that will work in 17.5, and maybe even simpler technique, but essentially the same, the point is that you have to have the pieces separate to begin with and then Weld will just temporarily weld them until the threshold is reached

saliva_test_fix_17.5.hipnc

Thank you very much for the answer!

I think i know a little now.

I tried this.

However, some parts are not cut off.

Can you help me?

Thank you.

saliva_test_2.hipnc

Share this post


Link to post
Share on other sites

depends on your breaking threshold, it's too high, but also as I mentioned before

14 hours ago, anim said:

you had some additional Stitch constraints being created in the dops so I disabled those otherwise they'd stitch those breaks back again

you had that enabled again in your new file

saliva_test_2_fix.hipnc

  • Thanks 1

Share this post


Link to post
Share on other sites
On 2020. 5. 21. at 6:13 PM, anim said:

depends on your breaking threshold, it's too high, but also as I mentioned before

you had that enabled again in your new file

saliva_test_2_fix.hipnc

I was missing a lot. Thank you so much for your help !!

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×