Whatsinaname 13 Posted September 11, 2020 I'm using a Gas Damp Microsolver to slow down my pyro sim. However, it seems like it is broken (H17.5.258). No matter which parameter I change, it sucks out all momentum of the sim, bringing it to a standstill. I'm using really ridiculous values, like a Target Speed of 500 (my sim is waaaay slower than that.) As far as I understand it, values below 500 should be ignored, but no matter what I put in there as a target speed, all velocities are lost after a few frames. Scale...well, if it's 1, 0.1, 0.0001 or whatever...it kills all motion after a few frames. Controlling it by a field...same result. Did anybody else ever have a similar issue with this particular microsolver? Share this post Link to post Share on other sites
