Jmg07 0 Posted February 14 Hi. I'm trying to model a needle. The cylinder is created by sweeping a circle down a line. Then polyextruding the resulting tube so it has a bit of thickness to it. I'm stuck trying to cut the end off diagonally. I'm just after some confirmation the polycut or polysplit would be appropriate nodes to do this (i tried using them but lucked out). Or if there are better suggestions that'd be great. Thx Share this post Link to post Share on other sites
konstantin magnus 808 Posted February 14 The shear transformation can create an angle. needle.hipnc 1 Share this post Link to post Share on other sites
Aizatulin 124 Posted February 14 Hi, you can use boolean with a big box for example and apply bevel on the abseams (if wanted). Here is an example needle.hipnc 1 Share this post Link to post Share on other sites