Jump to content
Sign in to follow this  
Ikuya

How to add a surface on the side of two curves.

Recommended Posts

Hi guys, I'd like to add surface to the sides of these two curves, but I can't quite get it to work. Any advice would be greatly appreciated.

2021-10-12_17h16_07.thumb.jpg.50eb288f5792c53f40e9b53e6b9c48c7.jpg

untitled.hip

Share this post


Link to post
Share on other sites

You can use Polyloft for it. But in order for it to work all curves must be the same kind. Yours is a mix of nurbs and polygons.

Polyloft works best if both curves have equal amount of points.

untitled.hip

  • Like 1

Share this post


Link to post
Share on other sites

Thank you for your advice on my basic questions, I now understand how to use Polyloft properly. In addition, Skin works fine. Thank you very much.

2021-10-12_21h47_50.thumb.png.0d7b721e8350a4681e53b6edf975efdc.png

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×