kidsreturnjj Posted September 13, 2013 Share Posted September 13, 2013 (edited) I'm making cherry blossom tree, and studying with CMIVFX L-system tutorial. When I make polygon on curve of Lsystem by Polywire node, some of joint part polygons are always crumpled as below picture. How can I approach this problem? I would like to get some advice. Thx. CMIVFX_end09.hipnc Edited September 13, 2013 by kidsreturnjj Quote Link to comment Share on other sites More sharing options...
old school Posted September 16, 2013 Share Posted September 16, 2013 Bypass the resample2 Resample SOP near the end of your SOP chain. There are too many tight divisions along the curves around the joints to form that triple forking joint properly. You could remove some of the points around the joint if you wanted control in that area. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.