sefisec Posted October 13, 2020 Share Posted October 13, 2020 (edited) Having a problem with a Motor in a Cone Twist Relationship for a few days. It's stop working after 50 frames (not generating any torque) if I animate a motor values. Parameters animated like 0 to 30 to 0 to 45 to 0 to -45 to 0 etc.., so motor should only increment a small angle per timestep. Tried to modify almost any parameter I could from lowest to highest, no success (apart from Time Scale, but it's not really a solution). Simulation substeps don't have visible effect either. Minimal working setup in the attached file. Banging my head against this problem for a couple days CT_problem_apprentice.hipnc Edited October 13, 2020 by sefisec Quote Link to comment Share on other sites More sharing options...
sefisec Posted October 13, 2020 Author Share Posted October 13, 2020 Ugh, I found, I missed Relaxation Factor parameter, that was the problem. Classic case of solving problem almost immediately after asking the question :D, even tho I couldn't solve it for a two days before Quote Link to comment Share on other sites More sharing options...
Librarian Posted October 13, 2020 Share Posted October 13, 2020 Nice @sefisec please post file for that parametar for the future investigation .. Quote Link to comment Share on other sites More sharing options...
sefisec Posted October 13, 2020 Author Share Posted October 13, 2020 2 hours ago, Librarian said: Nice @sefisec please post file for that parametar for the future investigation .. Sure, only parameter that different is Relaxation Factor (set to 0.3) of Cone Twist Constraint, that was enough to get it working. CT_problem_apprentice.hipnc 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.