Atom Posted July 15, 2021 Share Posted July 15, 2021 (edited) I'm trying to put together a mock-up of the 2013 Netflix logo. I have the basic elements in place, but how would I "ramp" or "delay" the zscale attribute for the polyextrude? Right now each letter of the logo pops on. I would like them to extrude up over time. ap_netflix_logo_2013.hiplc Edited July 15, 2021 by Atom Quote Link to comment Share on other sites More sharing options...
Pirminus Posted September 22, 2021 Share Posted September 22, 2021 Hey there, reworked a little bit of the setup. It works without a bounding box now. Hope this is what you are looking for. Kind Regards Pirmin ap_netflix_logo_2013_reworked.hiplc 1 Quote Link to comment Share on other sites More sharing options...
Atom Posted September 22, 2021 Author Share Posted September 22, 2021 Thanks. I was able to get what I need using MOPs, but your solution works too! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.