thejedi Posted November 23, 2020 Share Posted November 23, 2020 Hi everyone Im trying to get vellum dop system to emitt particles only between certain frames (Please see attached picture) Is there any ways of controlling vellum dop so that it triggers the simulation only at specific frames? something like $SF>11 & $SF<16 that one can use in the POP source's impluse activation? At the moment it seems to only accept one rule of emitting at a particular frame and it does not stop emitting I tried setting the emission type to continuous but that doesnt work either Thank you Quote Link to comment Share on other sites More sharing options...
Noobini Posted November 24, 2020 Share Posted November 24, 2020 try && instead of just one Quote Link to comment Share on other sites More sharing options...
thejedi Posted November 24, 2020 Author Share Posted November 24, 2020 Thanks Noobini for the tip. I tried it but it didnt work. Thanks for the tip regardless, Noobini. I like your name its very unique like mine Quote Link to comment Share on other sites More sharing options...
bRegenerative Posted December 4, 2020 Share Posted December 4, 2020 Maybe... ...verify that you have a one-to-one point correspondence between the surface geometry and the constraint geometry of the Vellum patch? ...try Continuous again, using full frame expressions (since geometry does not add during substeps? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.