Fiszka Posted June 7, 2017 Share Posted June 7, 2017 Hey. I have a problem with overwriting values from wire object in SOP Solver. If klinear parameter (Linear Spring Constant) is set to 300 in wire object and then I'm writing inside sopsolver in point wrangle @klinear = 300; just for test, then my simulation looks different, less stabile (?). Why is that happening? This is the same value so it should be the same sim. I was trying to put sopsolver before and after the wire solver and there was the same situation. Quote Link to comment Share on other sites More sharing options...
Skybar Posted June 7, 2017 Share Posted June 7, 2017 It's a multplier isnt it, so you effectively got 300*300=90000 ? 1 Quote Link to comment Share on other sites More sharing options...
Fiszka Posted June 7, 2017 Author Share Posted June 7, 2017 Hmm. Actually it's not a multiplier. If there's value 300 in wire object and @klinear = 1; in sopsolver then the value is much closer to 1 then 300. Quote Link to comment Share on other sites More sharing options...
Fiszka Posted June 7, 2017 Author Share Posted June 7, 2017 (edited) Ok. Sorry, it's my bad. It looks like it's multiplier Thanks a lot, it's working But why it's doing multiplication? How does it work? Edited June 7, 2017 by Fiszka Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.